Assorted Robotics Parts and Hardware / ServoCity / goBilda

Description

For sale is an assortment of robotics and 3D printed components. These parts were used for a university junior level design challenge and the majority were purchased from ServoCity. Included are a range of aluminum and steel components such as axles and U-channels, wheels and hubs, two steel bevel gear sets, four slide rails, and three continuous rotation servo motors. Some of the non-electronic components have been modified but not in a way that should impair normal use. Also included are several screws, nylock nuts, standoffs, brackets, and 3D printed parts. Most of the nuts and screws are 6/32" sized and have assorted heads such as pan head or flat head. Please expect some wear and tear on the components. Hopefully this will make for a good starting point for a school or personal project.
Over 0 worth of parts, asking 0 but will take offers.
3x goBilda 2000 Series Servo (these may need a servo programmer from ServoCity)
2x Servo to 1/4" Shaft Coupler
2x Bevel Gear Set
2x Ball Bearing Pillow Block
4x 8.4" Slide Rails
3x 4-hole U-channel
1x 3-hole U-channel
3x Standard Servo Plate B (two of these are lightly modified)
4x 4.90" Skate Wheel
4x Skate Wheel Mount for 1/4" Shaft
4x 2" Acrylic Disc Wheel
4x 1/4" Shaft Clamp Collar
4x Acrylic Wheel Hub
2x 10" D-Shaft
1x 3" D-Shaft
6x 2" D-Shaft (two of these have been filed down slightly)
0.5" Standoffs
0.75" Standoffs
Sold as is. No returns accepted.